updated ui added new features

third_party/codec2/unittest/check_peak.sh

@@ -0,0 +1,58 @@
+#!/usr/bin/env bash
+#
+# Check peak level of each FreeDV waveform is about the same to present
+# consistent drive to transmitters.
+#
+# For manual run outside of ctest:
+#  cd codec/build_linux
+#  PATH=${PATH}:${HOME}/codec2/build_linux/src
+#  ./unittest/check_peak.sh
+#  OR:
+#  
+
+voice_test() {
+    mode=$1
+    echo -n "$mode "
+    f=$(mktemp)
+    freedv_tx $mode ../raw/ve9qrp_10s.raw $f --clip 1
+    octave_cmd="cd ../octave; 
+                t=load_raw('${f}'); 
+                mx=max(t); printf('%d ',max(t)); 
+                if (mx > 16000) && (mx < 17000) printf('PASS\n') else printf('FAIL\n') end"
+    octave-cli -qf --eval "$octave_cmd"
+}
+
+data_test() {
+    mode=$1
+    echo -n "$mode "
+    f=$(mktemp)
+    freedv_data_raw_tx --framesperburst 2 --bursts 3 --testframes 6 $mode /dev/zero $f 2>/dev/null
+    octave_cmd="cd ../octave; 
+                t=load_raw('${f}'); 
+                mx=max(t); printf('%d ',max(t)); 
+                if (mx > 16000) && (mx < 17000) printf('PASS\n') else printf('FAIL\n') end"
+    octave-cli -qf --eval "$octave_cmd"
+}
+
+if [ "$1" == "LPCNet" ]; then
+    # these don't get run unless we build with LPCNet
+    voice_test "2020"
+    voice_test "2020B"
+  else
+    voice_test "1600"
+    voice_test "700C"
+    voice_test "700D"
+    voice_test "700E"
+    voice_test "800XA"
+    voice_test "2400A"
+    voice_test "2400B"
+    data_test "datac0"
+    data_test "datac1"
+    data_test "datac3"
+    data_test "datac4"
+    data_test "datac13"
+    data_test "datac14"
+fi
+
+exit 0
+